Successfully reported this slideshow.
We use your LinkedIn profile and activity data to personalize ads and to show you more relevant ads. You can change your ad preferences anytime.
Upcoming SlideShare
Swine flu
Next
Download to read offline and view in fullscreen.

1

Share

Download to read offline

HDMI

Download to read offline

Related Books

Free with a 30 day trial from Scribd

See all

HDMI

  1. 1. DISPLAY HDMI
  2. 2. What is HDMI • HDMI – High-Definition Multimedia Interface* – Allows for transmission of digital audiovisual content on the same physical link (DVD player, TV’s, set top boxes etc…) – Digital interface defined around DVI1.0 specification and backwards compatible with DVI – Command and control data (DDC) • Content Protection via HDCP (High Definition Content Protection) • Administered by HDMI * LLC (Limited Liability Corporation) – Licensing and Royalty fees apply • Transfer rate depends on display mode. – Spec range 25MHz to 340MHz (dense spectrum of frequencies) – Max speed is a product decision. IBX, CPT max: 222.5MHz
  3. 3. HDMI Overview EDID ROM HDMI Sink (Rx) HDMI Transmitter Video Audio Control/Status TMDS Channel 0 HDMI Receiver TMDS Channel 1 Display Data Channel (DDC) HDMI Source (Tx) Video Audio Control/Status TMDS Clock Channel TMDS Channel 2 HDMI Cable CEC HPD Main Link: 250Mbps to 3.4Gbps per channel, 25-340MHz sideband clock RGB or YCbCr 444 or 422, TMDS and TERC4 encoding 3.3V Rx termination, ~500mV swing based on DVI 1.0 Spec accounts for AC coupling tolerance on Sink (not Source) DDC: 100 KHz, I2C format, 3.3 - 5V HPD: Hot Plug Detect, 2 - 5V CEC: Optional 400 Hz bus, 2.5 – 3.3V (We do not support CEC)
  4. 4. HDMI Overview DDC Display Data Channel (HDMI) transmitter A device with an HDMI output. (HDMI) receiver A device with an HDMI input. TMDS clock is used by the receiver as a frequency reference for data recovery on the three TMDS data channels. • HDMI has three physically separate communication channels, which are the DDC, TMDS, and the optional CEC – The HDMI cable and connectors carry four differential pairs that make up the TMDS data and clock channels. » Audio, video and auxiliary data is transmitted across the three TMDS data channels. » A TMDS clock, typically running at the video pixel rate, is transmitted on the TMDS clock channel
  5. 5. HDMI Overview – HDMI carries a VESA DDC channel. The DDC is used for configuration and status exchange between a single transmitter and a single receiver. » The DDC is used by the transmitter to read the receiver’s Enhanced Extended Display Identification Data (E-EDID) in order to discover the receiver’s configuration and capabilities. – The optional CEC protocol provides high-level control functions between all of the various audiovisual products in a user’s environment.
  6. 6. HDMI Overview • There are 3 Types of HDMI connector, Type A , B and C. All three connectors carry all required HDMI signals, including a TMDS link. • The Type B connector is slightly larger and carries a second TMDS link, which is necessary to support very high resolution displays using dual link. • The Type C connector carries the same signals as the Type A but is more compact and intended for mobile applications. • The HDMI connector provides a pin allowing the transmitter to supply +5.0 Volts to the cable and receiver. • All HDMI transmitters shall assert the +5V Power signal whenever the transmitter is using the DDC or TMDS signals
  7. 7. HDMI Overview
  8. 8. HDMI Link • The HDMI link operates in one of three modes: • Video Data Period - the active pixels of an active video line are transmitted • Data Island period - audio and auxiliary data are transmitted using a series of packets. – This auxiliary data includes InfoFrames and other data describing the active audio or video stream or describing the transmitter. • Control period- It is used when no video, audio, or auxiliary data needs to be transmitted. It is required between any two periods that are not control periods.
  9. 9. Video Data on HDMI • Video data can have a pixel size of 24, 30, 36 or 48 bits. Color depths greater than 24 bits are defined to be “Deep Color” modes. • Video at the default 24-bit color depth is carried at a TMDS clock rate equal to the pixel clock rate. • Video Pixels Video Data Coding is such that the 8 bits converted to 10 bits by HDMI transmitter. • The video pixels can be encoded in either RGB, YCBCR 4:4:4 or YCBCR 4:2:2 formats. • Deep Color modes are optional though if an HDMI transmitter or receiver supports any Deep Color mode*, it shall support 36-bit mode.
  10. 10. HDMI Frame Composition •Example frame: 1280x1024 resolution •Vertical and horizontal blanking filled by control sequences – Color depth control information – TERC4 encoding used – HDMI specific controls •Pixel periods filled with TMDS-encoded active pixel data •Quick pixel clock Calculation: •HT*VT*Refresh Rate •1440*1054*60=91.0656MHz
  11. 11. EDID Extended display identification data • HDMI transmitter shall read the EDID and first CEA Extension to determine the capabilities supported by the receiver. • HDMI transmitter shall check the E-EDID for the presence of an HDMI Vendor Specific Data Block within the first CEA Extension to determine whether it is an HDMI/DVI device. • All the receiver supports 640 * 480P video format by default.
  12. 12. Hot-Plug detect • An HDMI receiver shall assert high voltage level on its Hot Plug Detect pin when the E- EDID is available for reading. • HDMI receiver shall indicate any change to the contents of the E-EDID by driving a low voltage level pulse on the Hot Plug Detect pin.
  13. 13. HDMI Usage History: HDMI is based on DVI • HDMI is REQUIRED BY SPEC to interoperate with DVI – Simple cable adapter is all that is allowed • DVI = Digital Visual Interface; used on PC’s (and some TV’s) • Almost identical electrical spec, same coding and clocking • HDMI connector is smaller than DVI, but same digital signals • HDMI adds audio packets, “info frames”, compliance testing Interface to Consumer Electronics displays (TV) • Set-top box to TV • DVD player to TV • Input to DVD burner (Content protection application) Interoperate with DVI • HDMI on DVD player to DVI on PC display • DVI on PC to HDMI display OR External Cable LCD Monitor DVI HDMI HDCP CE TV
  14. 14. Red 1TMDS Red TMDS CLK Green 1TMDS Green Blue 1TMDS Blue Red 2 Green 2 Blue 2 Red 3 Green 3 Blue 3 Red 4 Green 4 Blue 4 10-bit TMDS Code 10-bit TMDS Code 10-bit TMDS Code 10-bit TMDS Code Red 5 Green 5 Blue 5 10-bit TMDS Code TMDS Code and Clock HPD •HDMI main link is called the “TMDS Channel” – Three “TMDS” differential data lanes • Red, Green, Blue each have a lane • 10 bit “TMDS” coded data – TMDS is only used on HDMI and DVI – TMDS Clock lane • Clock is 1/10 bit rate – We send TMDS clock as a data pattern: 0000011111
  15. 15. HDMI TMDS Clock to Pixel Relationship TMDS Clock is 1/10 bit transfer rate 8 Bit Per Component Example: • 8 bits per color = 24 bits per pixel • Each 8 bit color value is coded as a 10-bit TMDS code, mapped to one Tx lane • TMDS clock runs at 1/10 the serialized bit rate, so … • 1 TMDS clock = 1 pixel For 1600x1200@24bpp, 60Hz refresh, pixel clock ~162MHz TMDS Clock = 162MHz; Bit rate per lane = 1.62GT/s Red 1TMDS Red TMDS CLK Green 1TMDS Green Blue 1TMDS Blue Red 2 Green 2 Blue 2 Red 3 Green 3 Blue 3 Red 4 Green 4 Blue 4 10-bit TMDS Code 10-bit TMDS Code 10-bit TMDS Code 10-bit TMDS Code Red 5 Green 5 Blue 5 10-bit TMDS Code Pixel 1 Pixel 2 Pixel 3 Pixel 4 Pixel 5
  16. 16. HDMI/DVI Main Link Topology – DC coupled to Rx 3.3V termination • Process scaling issues • Back-power issues for Tx – Signal amplitude is the same for all modes / speeds / channels • No power or EMI savings for short cables • Signal integrity suffers at higher speed HDMI or DVI “Spec” Tx HDMI TV Or DVI MONITOR AVcc = 3.3V RT = 50ohmsRT MOTHER BOARD HDMI SOURCE SINK HDMISource CONNECTOR ~11” Trace HDMISink CONNECTOR 2m – 15m Cable (TYP)HDMI CABLE TMDS Data or Clock Lane: Electrical Spec and Compliance Testing at Connectors
  17. 17. HDMI* Connector Design HDMI Type A 14 mm(W) x 5 mm(H) 37 mm(W) x 10 mm(H) DVI1.0 Connector HDMI Type C 10.5 mm(W) x 2.5 mm(H) • HDMI main link, HPD and DDC signals match single channel DVI • HDMI type A and C connectors have the same signals • Type C targets small form factors • HDMI type B connectors are not in use
  • htetaungphyo

    May. 9, 2015

Views

Total views

1,324

On Slideshare

0

From embeds

0

Number of embeds

221

Actions

Downloads

28

Shares

0

Comments

0

Likes

1

×