Huawei

1. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

2. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

3. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

4. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

5. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

6. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

7. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

8. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

9. Insufficient resources for scheduling(RB Number&Grant)
LTE Traffic Fault Diagnosis (Drive Test)
[Probe] The number downlink/uplink Grant times is less than 0.9 multiplying the
theoretical value.
[Probe] The number of PDSCH RBs is less than the theoretical RB value for the total
system bandwidth multiplying 0.9.
Coding with low values (MCS, IBLER, and Rank)
[Probe] The downlink or uplink IBLER is greater than 12%.
[U2000] For interference detection monitoring in cell performance monitoring,
there is an interference value of an RB greater than –120 dBm (eRAN3.0) or –110
dBm (eRAN6.0).
The Rank2 ratio is less than 80%.
Poor coverage
[Probe] Downlink: The SINR is lower than 25 dB (in the peak rate test scenario), or
the RSRP difference between the local cell and a neighboring cell is lower than 10
dBm.
[Probe] Uplink: During the uplink test, the path loss is lower than 100, the PUSCH
power is greater than 20 dBm, the IBLER converges to 10%, and the MCS is low
(the MCS should be greater than 23 according to the peak rate requirement).
Abnormal receive power
[Probe] The average difference between RSRPs of two antennas in the downlink is
greater than 3 dB.
Confidential Information of Huawei. No Spreading Without Permission

10. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

11. Based on problem scenarios, use different methods to check for operations and external
LTE Traffic Fault Diagnosis (Drive Test)
events that affect the service rate.
For performance deterioration problems, perform this step first to determine the
correlation between the external events/historical operations and the deterioration events
in terms of time/scope.
For multiple faulty eNodeBs, focus on operations that affect network performance, such as
EPC or transmission operations. For eNodeB-level operations, select top 10 cells for analysis
Confidential Information of Huawei. No Spreading Without Permission

12. The Hardware Module is faulty:
LTE Traffic Fault Diagnosis (Drive Test)
ALM-26532 RF Unit Hardware Fault
ALM-26538 RF Unit Clock Problem
ALM-26506 RF Unit Optical Interface Performance Degraded
The coverage shrinks, therefore the service rate is affected:
ALM-26520 RF Unit TX Channel Gain Out of Range
Handover failure may happen and the service rate is affected:
ALM-29204 X2 Interface Fault
Uplink demodulation performance may be affected:
ALM-26521 RF Unit RX Channel RTWP/RSSI Too Low
Uplink coverage shrinks:
ALM-26522 RF Unit RX Channel RTWP/RSSI Unbalanced
ALM-26787 RHUB-pRRU CPRI Interface Error
ALM-26758 TMA Running Data and Configuration Mismatch
ALM-26755 TMA Bypass
ALM-26530 RF Unit ALD Current Out of Range
Confidential Information of Huawei. No Spreading Without Permission

13. Influence by PDCCH Symbol Number
LTE Traffic Fault Diagnosis (Drive Test)
Downlink data transmission throughput strongly associated with the number of
PDCCH symbols. The default is the symbol 3 PDCCH adaptive. When peak test, we
can manually set the initial number of symbols of PDCCH to be 1.
Influence by fast ANR
eNodeB will be automatically selected at random to support fast ANR UE. UE will
continue to report neighborhood information to the eNodeB, which would affect
the UE uplink throughput. If the fast ANR is enabled, the rate of the selected UE
will be decreased by 1/4.
Influence by Frequency Selective Scheduling
If this scheduling is enabled, the Ues can only part of the frequency instead of all
frequency. Therefore the throughput will be affected.
Confidential Information of Huawei. No Spreading Without Permission

14. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

15. -l 1400: Indicates the injected packet length. The default value is 1498 bytes (measured at the IP
layer, including the IP header). This parameter must be set at both the sender and receiver.
LTE Traffic Fault Diagnosis (Drive Test)
layer, including the IP header). This parameter must be set at both the sender and receiver.
-p 5010: Indicates the injecting port. The default value is 5001. This parameter must be set at both
the sender and receiver. Note that this parameter at the sender indicates the injecting port and the
one at the receiver indicates the receiving port.
-P 2: Indicates two injecting threads. Assuming that the injecting rate is 1 Mbit/s (indicated by -b 1m),
the injecting rate becomes 2 Mbit/s if two threads are used to inject packets. This parameter is set on
the sender only.
Injecting TCP packets
To set up a receiving service in the receiver, run the iperf –s –i 1 –w 512k command,
Where –s indicates receiving service, –i 1 indicates that the received traffic volume is
displayed once per second, and –w 512k indicates that the receive window of the receiver
is 512 KB. This command lacks the –u option in comparison with the command executed
for UDP at the receiver.
Run the iperf –c x. x. x. x –t 1000 –i 1 –w 512k command,
where –c x. x. x. x indicates the IP address that the sender is connected to, -t 1000 indicates
inject duration of 1000 seconds, -i 1 indicates that the injected traffic volume is displayed
once per second, and -w 512k indicates that the receive window of the sender is 512 KB.
Other parameters are explained as follows:
-M 1400: Indicates the maximum segment size (MSS) of TCP packets, excluding the IP
header and TCP header. The default value is 1460 bytes. This parameter must be set at both
the sender and receiver.
-p 5010: Indicates the injecting port. The default value is 5001. This parameter must be set
at both the sender and receiver. Note that this parameter at the sender indicates the
injecting port and the one at the receiver indicates the receiving port.
-P 2: Indicates two threads for injecting or receiving packets. This parameter is set on the
sender only.
Confidential Information of Huawei. No Spreading Without Permission

16. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

17. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

18. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

19. If no route is configured, run the following command to configure the return route:
LTE Traffic Fault Diagnosis (Drive Test)
route add [service IP address of the UE] mask [subnet mask] [service IP address of
the server] –p
Confidential Information of Huawei. No Spreading Without Permission

20. If the aggregate maximum bit rate (AMBR) is set to 0, the UE can access the network but
LTE Traffic Fault Diagnosis (Drive Test)
fails in data transmission. In this case, check the AMBR value in the access message.
View the AMBR in the S1AP_INITIAL_CONTEXT_SETUP_REQ message traced over the S1
interface. If the AMBR value is 0, contact evolved packet core (EPC) personnel to modify
the AMBR.
Confidential Information of Huawei. No Spreading Without Permission

21. The ROHC feature provides an efficient header compression mechanism for RTP, UDP, and
LTE Traffic Fault Diagnosis (Drive Test)
IP packets to improve transmission efficiency and transmission quality and features high
compression ratio and robustness. In ROCH mode, data can be successfully transmitted
only when the ROCH feature is supported on the transmit and receive sides. Currently, only
four ROHC formats are supported by Huawei eNodeBs. Run the following command to
check whether the ROHC is enabled.
If a commercial UE does not support the ROHC and the ROCH is enabled on the eNodeB,
data transmission will fail. In this case, run the following command to disable the ROHC on
the eNodeB.
MOD PDCPROHCPARA:ROHCSWITCH=OFF;
Confidential Information of Huawei. No Spreading Without Permission

22. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

23. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

24. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

25. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

26. Figure shows injection of a 130 MB packet on the downlink and the ingress traffic on the
LTE Traffic Fault Diagnosis (Drive Test)
eNodeB is 131. 28 Mbit/s (16410349 x 8/1000/1000). The calculation result shows that
the traffic volume from the server to the core network and then to the eNodeB is sufficient.
If the RX traffic is smaller than the egress traffic of the server, the ingress traffic of the
eNodeB is restricted.
Confidential Information of Huawei. No Spreading Without Permission

27. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

28. Insufficient traffic volume at the eNodeB ingress is mostly caused by insufficient bandwidth
LTE Traffic Fault Diagnosis (Drive Test)
somewhere in the transmission link.
Confidential Information of Huawei. No Spreading Without Permission

29. UDP loopback working principle is: the peer set UDP loopback, the local sends UDP
LTE Traffic Fault Diagnosis (Drive Test)
packets to the peer. The peer reverses the source address and destination address of the
received packets and sends the UDP packets back to the source station. The local side
makes the statistics by returned UDP packets, thus continuity and quality of transmission
can be detected.
Confidential Information of Huawei. No Spreading Without Permission

30. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

31. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

32. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

33. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

34. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

35. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

36. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

37. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

38. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

39. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

40. The channel/interference check is performed only after the association verification is
LTE Traffic Fault Diagnosis (Drive Test)
passed and you determine that the problem is caused by a channel fault or interference.
Confidential Information of Huawei. No Spreading Without Permission

41. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

42. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

43. Analyze a TCP problem as follows:
LTE Traffic Fault Diagnosis (Drive Test)
If the throughput is stable but cannot reach the peak value, check the window
parameters and RTT.
If the throughput can reach the peak value but is unstable and may suddenly fall to
a low value, check for packet loss and disorder.
Confidential Information of Huawei. No Spreading Without Permission

44. Optimization of the sending and receiving windows in Win 7
LTE Traffic Fault Diagnosis (Drive Test)
In Windows 7, the TCP performance is automatically optimized by the TCP auto
tuning function. Start the Windows command line as an administrator and run the
following commands:
netsh int tcp set heuristics disabled
netsh int tcp set global autotuninglevel=normal
If the command is executed successfully, a confirmation message is returned. The
commands take effect immediately. There is no need to restart the computer. You
can run the following command to check the current system configuration level:
netsh int tcp show global
Confidential Information of Huawei. No Spreading Without Permission

45. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

46. Run the LST TYPDRBPUCCH command to query the SR period of each QCI.
LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

47. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

48. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission

49. First start the IFTS trace and then start TCP traffic. Stop IFTS trace upon completion of the
LTE Traffic Fault Diagnosis (Drive Test)
TCP traffic and save the .tmf trace file for analysis.
IFTS Trace is used to trace information of a UE served by a specified cell, including S1, X2
and Uu interface information at the control plane and data transmission statistics at the
user plane. The traced information can be saved automatically or manually and viewed
online or offline.
IFTS: Intelligent Field Test System
Confidential Information of Huawei. No Spreading Without Permission

50. LTE Traffic Fault Diagnosis (Drive Test)
Confidential Information of Huawei. No Spreading Without Permission