1. ATG Web Commerce 10.2
Commerce Reference Store
Installation
- Keyur Shah (http://www.linkedin.com/in/keyurkshah)
2. ATG CRS – Installation
STEP – 1 (Launch the installer executable)
Once you have installed the ATG
Web Commerce 10.2 on your
development system
Next step is to install the
Commerce Reference Store
To initiate the ATG 10.2
Commerce Reference Store
installation, run the executable
“CommerceReferenceStore10.2_
354.exe” on the Windows 64-bit
platform as highlighted in the
screenshot
3. ATG CRS – Installation
STEP – 2 (Language Selection)
You will land on this screen,
once you launch the
installer executable, and it
prepares the setup program
to continue
You can pick the language
of choice (“English” in this
case) and continue
Hit the OK button to
continue with the installation
4. ATG CRS – Installation
STEP – 3 (Introduction)
The setup program will
walk you through
several steps as outlined
on the LEFT
Starting with
Introduction to the
InstallAnywhere
program & the actions
you need to perform to
continue
Hit Next to continue with
the installation
5. ATG CRS – Installation
STEP – 4 (License Agreement)
In this step you will be
required to “ACCEPT”
the terms of the license
agreements, in order to
continue with the
installation
Select “I Accept”, which
will enable the Next
button
Hit Next to continue with
the installation
6. ATG CRS – Installation
STEP – 5 (Choose Install Folder)
In this step you need to
select the folder/drive
where you want the
installer to extract the
ATG Web Commerce
platform files
E.g. C:ATGATG10.2
I’m sure some of
developer friends might
actually use drives other
than C
Hit Next to continue with
the installation
7. ATG CRS – Installation
STEP – 6 (Choose Shortcut Folder)
This step is the same as
all other windows
installation program
prompts
You need to decide
where you want to
place the shortcut
icons/menu
I would use the default
selection
Hit Next to continue
8. ATG CRS – Installation
STEP – 7 (Pre-Installation Summary)
In this step you can
review your responses to
previous prompts
Verify & Change (if
need be)
Hit Install to perform the
ATG Web Commerce
setup using the inputs
listed in this section
9. ATG CRS – Installation
STEP – 9 (Installing & Done)
Once the installer is done copying all the necessary files to the destination
folder, 100% - will give you the indication about completion.
Click DONE to exit the installer