WeatherockGroup worldwide is one of the world's top manufacturers & Supplier of top-quality Double Submerged arc welded (DSAW) Pipe and Longitudinal Welded Pipe. Our high-performance products include Induction Bend Pipe Manufacturers

1. What is Induction Bend Pipe
Manufacturers
Induction Bend Pipe is a process when the heat is used on a particular area of a metal
section- pipe or tube, to allow it to bend easily. The heat is applied using an induction coil
heated to a preset temperature to give the metal a bend of a preset radius. The process is
also often referred to as hot pipe bend.
The temperature of the coil ranges from 800-2,200 degrees depending on the type of metal,
its grade, temper, and thickness of the section. The process involves applying pressure on
the metal while the coil is hot thereby allowing for easy bending. Once the desired radius of
the bend is achieved, the section is cooled with water or air spray.
The benefits of Induction Bend Pipe:
There are several advantages of bending metal pipes using this technique:
Since the process involves heating a particular area of the pipe, it ensures that the distortion
on the section is minimal once the bending process is completed.
The amount of energy required to carry out the process is minimum, the process results in
systems that have higher energy efficiency.
Induction Bend Pipe does not require internal mandrels and sand filling, thereby saving on
cost.
The process does not take very long compared to the other metal bending techniques,
thereby adding to its cost-efficiency.
The need for welded or mechanical joints is eliminated by this method which means that
there is no need for the surfaces for a neat finish.
The applications of Induction Bend Pipe:
The process of bending can be used for nearly any metal and even alloys such as steel and
all kinds of pipe sections. In typical cases, this metal bending technique is used on massive
pipes like petroleum pipelines. However, its use also extends to smaller pipe sections such
as farming tools and springs.
Induction Bend Pipe is often confused with hot rolling. The latter is quite different and it
involves changing the thickness and shape of the metal after heating it to a required
temperature called the critical temperature. The technique is generally used for metal
sheets where the entire sheet is heated and then rolled to the desired radius. Its
applications are limited because of it of its relatively lower cost-effectiveness and energy

2. efficiency. The sections thus produced are generally used as feed for rolling mills or directly
for fabrication.
WeatherockGroup worldwide is one of the world's top manufacturers & Supplier of top-
quality Double Submerged arc welded (DSAW) Pipe and Longitudinal Welded Pipe. Our high-
performance products include Induction Bend Pipe Manufacturers
Read More: - https://www.articleted.com/article/328716/16416/What-is-Induction-Bend-Pipe-
Manufacturers